This blog list 3 kinds of bmw diagnostic scanner ISTA errors and solutions you may need.
ISTA NCS error IFH-0010+ solution
ISTA error”MSVCP120.dll is missing”+ solution
ISTA error “The vehicle could not be identified”+ solution
Note: All error solutions here are suitable for BMW ICOM A2 and BMW ICOM Next!
ISTA error IFH-0010: DATATRANSMISSION TO CONTROLUNIT DISTURBED
ISTA error: A communication fault occurred during activation
Incorrect state: ERROR ECU CONDITIONS NOT CORRECT OR REQUEST SEQUENCE ERROR
Solution:
Try setting COM port latency to 1 in Advanced Settings for the port.
You should change it to 1 to have the least lag/disturbances between
data transfer.
BMW ISTA System error “MSVCP120.dll is missing”
The program can’t start because MSVCP120.dll is missing from your computer.
Solution:
Reinstall VC++ Redistributables and try again. If you’re running x64,
you will need both x86 and x64 bit versions installed.
Feedback: I got rid of this .dll error by installing an older version of VC++.
BMW
ISTA error “The vehicle could not be identified. Please check the
access to the vehicle and check whether the testing-analysis-diagnosis
has been activated.”
Solution 1: I changed my com port to port 1 and it worked. It’s worth a shot, easy to change back if it doesn’t work.
Solution 2: Uncheck the Ethernet box and BMW ICOM A2+B+C ISTA-D worked.
Feedback: I changed COM9 to COM1. Its working!
Subscribe to:
Post Comments (Atom)
-
BMW coding for your BMW 1, 2, 3, 4, 5, 6, 7, X, I, (2004-current E, F, and G, I chassis), and BMW Mini (R5x & F5x) Vehicles using...
-
I have read that BMW will stop support F and G series from Ista P. Is there somewhere a good tutorial how to install the new ISTA+ with al...
-
Problem: How to restore BMW icom next a2+B+C after a factory reset? LAN doesn’t work after reset. Answer: You need to restore it with usb d...
No comments:
Post a Comment